Cisco FastHub 100 series Installation Manual page 44

rps4 Page 8 Monday, September 14, 1998 8:19 AM
Connecting External Devices to the Cisco RPS
Step 4
Figure 4-6
Step 5
Step 6
4-8 Cisco Redundant Power System Hardware Installation Guide
On the rear panel of the Cisco RPS, connect an AC power cable to either or both
of the power connectors. Use cable locks—included with the Cisco RPS—to
lock the cables in place. (See Figure 4-6.)
Connecting the AC Power Cables to the Cisco RPS
Plug the other end of the Cisco RPS AC power cable into a grounded AC power
outlet at your site.
If you are using the redundant-with-reboot configuration, plug the hub AC
power cord into a grounded AC power outlet.
Cable locks