Cisco FastHub 100 series Installation Manual page 52

rps4 Page 16 Monday, September 14, 1998 8:19 AM
Connecting External Devices to the Cisco RPS
Step 7
Figure 4-16
Step 8
4-16 Cisco Redundant Power System Hardware Installation Guide
Power ON the Cisco RPS. There is one power switch for each of the AC input
power modules. Make sure the power switch for each connected AC cable is
ON (|). (See Figure 4-16.)
Powering ON the Cisco RPS
The Cisco RPS provides power in 10 to 15 seconds. The Cisco RPS is working
properly when all its front panel LEDs are solid green. If the external device
does not power up, refer to Appendix B, "Troubleshooting the Cisco RPS."
If you are using the redundant-with-reboot configuration, press the switch power
switch to ON (|) to begin providing power simultaneously with the Cisco RPS.