Advertisement
US6033 1
ADDITIONAL SAFETY RULES
1. Wear eye protection.
2. Keep hands out of path of saw blade. Avoid contact with any coasting blade.
It
can
3. Do not operate saw without guards
in
place.
4. Do not perform any operation freehand. The workpiece must be secured firmly against
the turn base and guide fence with the vise during all operations. Never use your
hand to secure the workpiece.
5.
Never reach around saw blade.
6. Turn off tool and wait for saw blade to stop before moving workpiece or changing
7. Remove battery from tool before changing blade or servicing.
8.
To
reduce the risk of injury, return carriage to the full rear position after each crosscut
9. Always secure all moving portions before carrying the tool.
still cause severe injury.
settings.
operation.
IO.
Stopper pin which locks the cutter head down is for carrying and storage purposes
11.
Be aware that this tool is always
in
an operating condition, because
it
does not have
12. Don't use the tool
in
the presence of flammable liquids or gases.
13. Check the blade carefully for cracks or damage before operation.
14. Use only flanges specified for this tool.
15.
Be careful not to damage the arbor, flanges (especially the installing surface) or bolt.
16. Make sure that the turn base is properly secured
so it
will not move during operation.
17. For your safety, remove the chips, small pieces, etc. from the table top before
18. Avoid cutting nails. Inspect for and remove all nails from the workpiece before
19. Make sure the shaft lock is released before the switch is turned on.
20. Be sure that the blade does not contact the turn base
in
the lowest position.
21. Hold the handle firmly. Be aware that the saw moves up or down slightly during start-up
22.
Make sure the blade is not contacting the workpiece before the switch is turned on.
23. Before using the tool on an actual workpiece, let
it
run for a while. Watch for vibra-
24.
Wait
until
the blade attains full speed before cutting.
25. Stop operation immediately if you notice anything abnormal.
26. Do not attempt to lock the trigger in the on position.
27. Be alert at all times, especially during repetitive, monotonous operations. Don't be
28. Always use accessories recommended
in
this manual. Use of improper accessories
only and not for any cutting operations.
to be plugged into an electrical outlet.
Replace cracked or damaged blade immediately.
Damage to these parts could result in blade breakage.
operation.
operation.
and stopping.
tion or wobbling that could indicate poor installation or a poorly balanced blade.
lulled into a false sense of security. Blades are extremely unforgiving.
such as abrasive wheels may cause an injury.
SAVE THESE INSTRUCTIONS.
5
Advertisement
