Advertisement
*There are crown and cove molding joints which are made to fit "Inside" 90" corners
( 0
and
0)
in Fig. C) and "Outside" 90" corners
(@
and
@
in Fig. C).
Bevel angle
Molding position
in Fig. (C)
52/38O type
45O type
0
0
0
@I
For inside corner
~
Left 30°
Left 33.9'
For outside corner
-
Inside corner
Outside corner
I
Miter angle
52/38' type
45O type
Right 31.6'
Right 35.3O
Left
31.6'
Left
35.3'
Right 31.6''
Right 35.3'
I
Fig. (Ct
Molding position
in Fig. (C)
Molding edge against guide fence
Ceiling contact edge should be
against guide fence.
For inside corner
Inside cornel
Finished piece
Finished piece will be on the
Left side of blade.
0
0
@I
For outside corner
Wall contact edge should be
against guide fence.
Finished piece will be on the
Right side
Of
blade.
Ceiling contact edge should be
against guide fence.
(Example)
In the case of cutting 52/38O type crown molding for position
@
in Fig. (C):
*Tilt and secure bevel angle setting to 33.9" LEFT.
*Adjust and secure miter angle setting to 31.6" RIGHT.
*Lay crown molding with its broad back surface down on the turn base with its CEIL-
*The finished piece to be used will always be on the LEFT side
of
the blade after the
ING CONTACT EDGE against the guide fence on the saw.
cut has been made.
22
Advertisement
