Advertisement
Carefully square the side of the blade
with the top surface of the turn base
using the triangular rule,
try
square,
etc. by turning the 0" bevel angle
adjusting bolt clockwise. Then tighten
the lever securely.
Make sure that the pointer on the arm
points to 0" on the bevel scale on the
arm holder. If it does not point to 0",
loosen the screw which secures the
pointer and adjust the pointer so that
it will point to 0".
ii) 45" bevel angle
Adjust the 45" bevel angle only after
performing 0" bevel angle adjustment.
To adjust left 45" bevel angle, loosen
the lever and tilt the blade 45" to the
left. Make sure that the pointer on the
arm points to 45" on the bevel scale
on the arm holder. If the pointer does
not point to 45". turn the 45" bevel
angle adjusting bolt (upper bolt) on the
right side of the arm until the pointer
points to 45".
Triangular rule
I
I
of
turn blase
I
Screw
45' bevel angle
adjusting bolt
r'
\
I
28
Advertisement
