Advertisement
If the charging light flashes alternately in green and red color, charging is not possible.
The terminals on the charger or battery cartridge are clogged with dust or the battery car-
tridge is worn out or damaged.
Trickle charge (Maintenance charge)
If you leave the batten/ cartridge in the charger to prevent spontaneous discharging after
full charge, the charger will switch into its "trickle charge (maintenance charge)" mode and
keep the battery cartridge fresh and fully charged.
Tips for maintaining maximum battery life
1 .
Charge the battery cartridge before completely discharged.
Always stop tool operation and charge the battery cartridge when you notice less tool
power.
2. Never recharge a fully charged battery cartridge.
Overcharging shortens the battery service life.
3. Charge the battery cartridge with room temperature at 10°C
-
40°C (50°F
-
104°F).
Let a hot battery cartridge cool down before charging it.
4.
Charge the Nickel Metal Hydride battery cartridge when you do not use it for more than
six months.
Socket wrench
The socket wrench is stored as shown in
the figure. When using the socket wrench,
pull it out of the wrench holder. After using
the socket wrench. return it to the wrench
holder.
Bench mounting saw
When the tool is shipped, the handle is
locked in the lowered position by the stop-
per pin. Release the stopper pin by lower-
ing the handle slightly and pulling the stop-
per pin.
lder
\
10
Advertisement
