Baumatic PECM1SS Instruction Manual page 29

Do not proceed with the rest of the installation steps listed
below, until you have completed the "Connecting the coffee
machine to the mains water supply" section on the next page.
You should also feed the electrical cable through the hole that you
have made for it in the housing unit. You should NOT connect the
cable to the spur outlet at this stage.
4. Place the coffee machine inside of the housing unit.
5. Sit the coffee machine in the housing unit. You must make sure
that the coffee machine is flush with the housing unit, otherwise
it will not line up properly with the support pieces.
6. There are two screw holes on the main body of the coffee maker,
one on the right hand side of the machine and the other on the
left hand side. You have to open the water reservoir door (14)
and remove the water reservoir (15) to access the left hand
one.
7. Fix the coffee machine against the housing unit by fully
tightening the screws provided, through the screw holes on the
above drawing.
8. Follow the electrical connection information on page 26 and then
check that the appliance is functioning correctly.
IMPORTANT: You must follow the "Before first use" section on
page 13.
29