Table of Contents
Advertisement
Dispensing boiling water
o Connect the spout for hot water (7) to the steam pipe (17) and
place the end of it into a cup.
o Fill the water reservoir if your appliance is not connected to your
mains water supply.
o Switch the machine on using the ON/OFF switch (20).
o Let the water reservoir fill with water automatically if it is
connected to your mains water supply.
o Once the machine has stopped filling and the water reservoir
empty neon (28) has gone out, press the water boiler ON/OFF
button (29). The water boiler neon (23) will flash to indicate
that the water boiler is heating up.
o The machine is ready to use when the water boiler neon (23)
stops flashing and remains lit.
o Press the steam boiler ON/OFF button (31).
o The steam boiler neon (25) will start to flash to indicate that the
steam boiler is heating up.
o Whilst the steam boiler is heating up, you may get a small
amount of water dripping from the steam pipe (17).
o The machine is ready to dispense boiling water when the steam
boiler neon (25) and the water boiler neon (25) both remain lit.
o To dispense boiling water, press the hot water dispensing button
(33).
o To stop boiling water from dispensing, press the hot water
dispensing button (33) again.
It is perfectly normal for there to be a noise and a small
amount of water backfilling into the drip tray, after water
has been dispensed.
16
Advertisement
Table of Contents
