Dispensing Steam - Baumatic PECM1SS Instruction Manual

Dispensing steam

o Connect the froth making spout (8) to the steam pipe (17) and
place the end of it into a cup. The froth making spout comes in
two parts, the spout itself and a plastic cover; both parts should
be connected to the steam pipe.
o Fill the water reservoir if your appliance is not connected to your
mains water supply.
o Switch the machine on using the ON/OFF switch (20).
o Let the water reservoir fill with water automatically if it is
connected to your mains water supply.
o Once the machine has stopped filling and the water reservoir
empty neon (28) has gone out, press the water boiler ON/OFF
button (29). The water boiler neon (23) will flash to indicate
that the water boiler is heating up.
o The machine is ready to use when the water boiler neon (23)
stops flashing and remains lit.
o Press the steam boiler ON/OFF button (31).
o The steam boiler neon (25) will start to flash to indicate that the
steam boiler is heating up.
o Whilst the steam boiler is heating up, you may get a small
amount of water dripping from the steam pipe (17).
o The machine is ready to dispense steam when the steam boiler
neon (25) and the water boiler neon (25) both remain lit.
o To dispense steam, press the steam dispensing button (32).
o To stop steam from dispensing, press the steam dispensing
button (32) again.
It is perfectly normal for there to be a noise and a small
amount of water backfilling into the drip tray, after steam
has been dispensed.
15