Troubleshooting; Common P Roduct Questions - Horizon Fitness T72 User Manual

i_ I _ )
i!l
i i i
i i
COMMON P RODUCT QUESTIONS
ARETHE SOUNDS M Y TREADMILL MAKES NORMAL?
All treadmills make a certain type of thumping noise clueto the belt riding over the milers,especially new
treadmills. This noise will diminish over time, although may not totally go away.Overtime, the belt will
stretch, causing the belt to ride smootherover the rollers.
WHYIS THETREADMILL I PURCHASED LOUDER THAN THEONE ATTHE STORE?
All fitness products seem quieter in a large store showroombecause there is generally morebackground noise
than in your home. Also, there will be less reverberation on a carpeted concretefloor than on a woodoverlay
floor. Sometimesa heavyrubber mat wifl help reducereverberation through the floor. If a fitness product is
placed close to a wall, there will be more reflected noise.
WHEN SHOULD I BE WORRIED A BOUT A NOISE?
As long as the soundsyour treadmill makesare no louder than a normal conversational tone of voice, it is
considered normal noise.
TROUBLESHOOTING- TREADMILL
Yourtreadmill is designed to be reliable and easy to use. However, i f you experiencea problem, please referencethe
troubleshootingguide fisted below.
PROBLEM:
Thebanding straps were
removed beforeASSEMBLY STEPI was
complete and the machine has sprung
open and cannot be assembled.
$_N: Theair shocks have been engagedprematurely. Tocorrect this, tilt the machine on it's noseby lifting
the cleck(light end) upwards. Step on the foot latch and folcl down the cleckso that it is horizontal. Youmay now
proceedwith ASSEMBLY S TEPI.
PROBLEM: Theconsolecloesnot fight up and/or the belt cloesnot move.
$QLgTIQN:
Verifythe following,
DOESTHEREDLIGHTONTHEON/OFF SWITCH LIGHTUP?
IF YES:
• Doublecheck that all connections are secure,especially the console cable. Unplug and reconnectthe console
cable to verify.
• Make sure the consolecable is not pinched or damaged in any way.
• Turnthe power off, unplug the power cable and wait 60 seconds. Removemotor cover. Wait until all red LED
lights havegone off on the motor control boardbeforeproceeding.Next, verify that noneof the wires connected
to the lower board are looseor disconnected.
IF NO:
Verifythat the outlet the machine is plugged into is functional Doublecheck that the breakerhas not tripped,
it is on a dedicated 20-amp circuit, it is not on a GFCI-equippedoutlet, and it is not plugged into a power
strip/surge protector or extensioncord.
Thepower corclis not pinched or damaged and is properlyplugged into the outlet AND the machine.
Thepower switch is turned to the ONposition.