Changing Image Scanner Name - Via Barcodes - Honeywell 2020 User Manual

Changing Image Scanner Name - via Barcodes

If you wanted to set up your image scanners with names 0001-0007, you may
scan the barcodes below. Scan the Reset barcode after each name change
and wait for the image scanner to re-link to the base before scanning the next
barcode to name the next image scanner.
Alternatively, you may change the name with a barcode command if you cannot
send serial commands to the base. One way to do this is to scan the barcode
below and scan a number for the image scanner name. For example, if you had
7 image scanners to one base, scan the barcode below with the first image
scanner, scan the 1 barcode on the
this manual and scan Save. Then scan the Reset barcode and wait for the
image scanner to re-link to the base before scanning the next barcode. Repeat
that process for image scanner number 2, 3, 4 etc.
If you want to assign an alphabetic name to the image scanner, create a Code
128 barcode containing "~BT_NAM name ." followed by a FNC3 character (hexi-
decimal 83), where name is the new image scanner name. Scan the Reset bar-
code (page 1-8 or on the
manual). You may use Barcode Builder, which is included with Quick*View.
You may download Quick*View from the Honeywell International Inc. website:
www.honeywell.com/aidc
1 - 8
0001
0003
0005
0007
Image Scanner Name
Programming Chart
.
Programming Chart
inside the back cover of this
0002 0002
0004
0006
Reset
inside the back cover of