Chapter 2 - Terminal Interfaces; Terminal Id - Honeywell 2020 User Manual

2
Terminal Interfaces

Terminal ID

If your interface is not a standard PC AT, refer to "Supported Terminals" on page
2-2 through page 2-3, and locate the Terminal ID number for your PC. Scan the
Terminal ID barcode below, then scan the numeric barcode(s) from the Pro-
gramming Chart inside the back cover of this manual to program the image
scanner for your terminal ID. Scan Save to save your selection.
For example, an IBM AT terminal has a Terminal ID of 003. You would scan the
Terminal ID barcode, then 0, 0, 3 from the Programming Chart inside the back
cover of this manual, then Save. If you make an error while scanning the digits
(before scanning Save), scan the Discard code on the Programming Chart,
scan the Terminal ID barcode, scan the digits, and the Save code again.
Note: The default interface for the 2020-5BE is Keyboard Wedge (Term ID =
003).
Terminal ID
Save
Note: After scanning one of these codes, you must power cycle your computer.
2 - 1