Resetting the Standard Product Default Settings:
Current Application Work Group
If you aren't sure what programming options are in your image scanner, or
you've changed some options and want the standard product default settings
restored, scan the Standard Product Default Settings: Current Application
Group barcode below.
The
Menu Commands
each of the commands (indicated by an asterisk (*) on the programming pages).
Note: Scanning this barcode also causes both the image scanner and the base
to perform a reset and become unlinked. Refer to
Scanner to Base"
Note: If your image scanner is in multiple image scanner mode and you scan
either the current or all application group default barcode, you will hear up
to 30 seconds of beeping while all image scanners are re-linked from the
base and the settings are defaulted to * settings. The default interface is
keyboard wedge and the default image scanner mode is single image
scanner locked link mode.
Resetting the Standard Product Default Settings:
All Application Work Groups
The following barcode defaults all of the work groups to the factory settings.
The
Menu Commands
settings for each of the commands (indicated by an asterisk (*) on the program-
ming pages).
starting on
page 10-6
on page 1-5 for additional information.
Standard Product Default Settings:
Current Application Group
Standard Product Default Settings:
All Application Groups
starting on
page 10-6
list the factory default settings for
"Linking Image
list the standard product default
1 - 11