Advertisement
Installing the Control Unit
55. Connect the antenna cable terminal and the
engine starter harness 18-pin connector to the
control unit.
CONTROL UNIT
BRACKET
56. Install the control unit on the control unit bracket.
57. Bundle the excess antenna cable with two wire
ties and secure it with one wire tie to the vehicle
harness.
WIRE
TIES
VEHICLE
HARNESS
16 of 21
www.collegehillshonda.com
ANTENNA CABLE
TERMINAL
(Connect first.)
FRONT
CONTROL
UNIT
ENGINE STARTER
HARNESS 18-PIN
6D01312T
CONNECTOR
ANTENNA
CABLE
7401020T
58. Using isopropyl alcohol on a shop towel, clean the
area where the engine starter label will attach.
HOOD
ENGINE
STARTER
LABEL
59. Attach the engine starter label to the back of the
hood.
60. Check that all wire harnesses are routed properly
and all connectors are plugged in.
61. Reinstall all removed parts. Check that all clips
and other fasteners are installed securely. Take
care not to pinch the airbag with a clip during
reinstallation of the front pillar trim. Do not push
the front pillar trim excessively.
62. Reconnect the negative cable to the battery.
Check that the electrical accessory and other
electrical systems function properly.
63. Perform REMOTE ENGINE STARTER
REGISTRATION, on pages 18-20, and FUNCTION
CHECK, on page 21.
64. Enter the customer's radio anti-theft code, and
reset the radio station presets.
65. Reset the clock.
AII 38216-38957 (0802)
ADHESIVE
BACKING
© 2008 American Honda Motor Co., Inc. - All Rights Reserved.
6D01421T
Advertisement
