Advertisement
www.collegehillshonda.com
45. With driver's dashboard under cover: Measure
the indicated dimension on the instrument panel
and mark with a felt-tip pen and a center punch.
INSTRUMENT
PANEL
View from below
FRONT
6 mm
(0.2 in.)
Drill a 3 mm hole and then a 7 mm hole at the
marked position of the instrument panel.
–
Wear safety goggles during drilling.
–
Using a file, remove the burrs at the edges
of the holes you made.
INSTRUMENT PANEL
© 2008 American Honda Motor Co., Inc. - All Rights Reserved.
12 mm
CENTER
(0.5 in.)
PUNCH
FELT-TIP PEN
6D01351T
DRILL BIT
(3 mm, 7 mm)
DRILL
6D01361T
AII 38216-38957 (0802)
46. Secure the engine starter harness to the vehicle
harness using a wire tie.
•
With driver's dashboard under cover: Secure
in the hole you made in the instrument panel.
•
Without driver's dashboard under cover:
Secure through the existing hole for under
cover securing.
FUSE
CLIP
BOX
47. Use the clip on the engine starter harness to
secure the engine starter harness to the fuse box.
WIRE TIE
WITH DRIVER'S
DASHBOARD UNDER
COVER
6D01172T
13 of 21
Advertisement
