Advertisement
31. Secure the antenna cable to the vehicle harness
with a wire tie. Secure the wire tie between the
vehicle harness branching points.
VEHICLE
HARNESS
BRANCHING
POINTS
Installing the Control Unit Bracket
32. Locate the small square hole next to the small
round hole in the dashboard support bracket.
Under the dash, attach the control unit bracket to
the vehicle bracket near the front lower pillar using
a flange nut. If the vehicle is equipped with a
moonroof, be careful not to pull on the drain tube.
VEHICLE
BRACKET
VEHICLE
BRACKET
CONTROL UNIT
BRACKET
10 of 21
www.collegehillshonda.com
WIRE TIE
ANTENNA
CABLE
6D01281T
FRONT
FLANGE
NUT
6D01123T
Routing the Engine Starter Harness
33. Attach the 3 A fuse labels to the engine starter
harness fuse case, and the 40 A fuse labels to the
fuse block.
LAYOUT OF RELAYS
WHEN VIEWED FROM FRONT
5-PIN
RELAY
(green)
CLIP
FUSE
BLOCK
34. Install the four relays to the engine starter harness
relay blocks. Be careful to install the relays
properly, or a malfunction will result.
AII 38216-38957 (0802)
4-PIN
RELAY
(black)
RELAY
BLOCK
40 A FUSE
LABEL
4-PIN RELAY
(black)
© 2008 American Honda Motor Co., Inc. - All Rights Reserved.
FUSE
CASE
3 A
FUSE
LABEL
6D01031T
Advertisement
