Setting The Control Unit; Removing The Vehicle Parts - Honda 08E91-E22-100B Installation Instructions Manual

www.collegehillshonda.com

Setting the Control Unit

3. Get the control unit. Using a small flat-tip
screwdriver, adjust the switches on the control
unit to the locations shown. Using a isopropyl
alcohol on a shop towel, clean the area where the
protective tape will attach. Attach the protective
tape to the control unit over the switches.
NOTE:
• The switches must be selected before the
control unit is plugged in.
• If the switch setting is not correct, the engine
starter will not operate correctly.
• If setting the switches when the control unit is
installed in the vehicle, touch a metal part of
the screwdriver to a metal part of the vehicle to
discharge any static electricity.
• If you change the switch settings with the unit
connected, you must disconnect the unit then
reconnect it before the settings will change.
CONTROL
UNIT
SMALL
FLAT-TIP
SCREW-
DRIVER
SWITCHES
SWITCHES
SW:1 RR Junction unit -----------------------> OFF
SW:2 Trunk or Tailgate ----------------------> OFF
SW:3 Smart Entry -----------------------------> OFF
SW:4 Horn or Buzzer Answerback ------> OFF
SW:5 Trunk Main SW -------------------------> OFF
SW:6 Reserve ----------------------------------> OFF
© 2008 American Honda Motor Co., Inc. - All Rights Reserved.

Removing the vehicle parts

4.
Discharge any
static electricity.
The switches must
be selected before
the control unit is
plugged in.
SET
AII 38215-38958 (0802)
SW : 1 RR Junction Unit
SW : 2 Trunk or Tailgate
SW : 3 Smart Entry
SW : 4 Horn or Buzzer Answer Back
SW : 5 Trunk Main SW
SW : 6 Reserve
Remove the trunk lid/fuel fill door opener cover
(six retaining tabs). Remove one self-tapping
screw.
SELF-
TAPPING
SCREW
Unlock.
KEY
COVER
6
RETAINING
TABS
TRUNK LID/
FUEL FILL
DOOR
OPENER
5202191T
3 of 22