Honda 08E91-E22-100B Installation Instructions Manual page 14

46. With driver's dashboard under cover: Measure
the indicated dimension on the instrument panel
and mark with a felt-tip pen and a center punch.
INSTRUMENT
PANEL
View from below
FRONT
6 mm
(0.2 in.)
• Drill a 3 mm hole and then a 7 mm hole at the
marked position of the instrument panel.
–
Wear safety goggles during drilling.
–
Using a file, remove the burrs at the edges
of the holes you made.
INSTRUMENT PANEL
14 of 22
www.collegehillshonda.com
12 mm
(0.5 in.)
CENTER
PUNCH
FELT-TIP PEN
6D01351T
DRILL BIT
(3, 7 mm)
DRILL
6D01361T
47. Secure the engine starter harness to the vehicle
harness using a wire tie:
• With driver's dashboard under cover: Secure
in the hole opened in the instrument panel.
• Without driver's dashboard under cover:
Secure through the existing hole for under
cover securing.
FUSE
BOX
48. Use the clip on the engine starter harness to
secure the engine starter harness to the fuse box.
AII 38215-38958 (0802)
WIRE TIE
WITH DRIVER'S DASHBOARD
UNDER COVER
CLIP
© 2008 American Honda Motor Co., Inc. - All Rights Reserved.
6D01172T