Fxo Calls Route To; Fxs - Digicom Wireless 3G Gateway User Manual

3G Gateway Series

5.3.1.2. FXO calls route to

With this menu you can configure the redirection of calls received on FXO port to FXS interface (FXS- DialThru gateway) or to
GSM/UMTS interface (GSM – FXO gateway).

5.3.2. FXS

Configuration of FXS (Tel) interface.
Enable CLIR (Caller Line ID Restriction)
If CLIR is enabled, 3G Gateway is set not to send its own number (SIM telephone number), the receiver will see "private
number".
CLI (Calling Line Identification)
FSK
NONE
Timeout for dialing (ms) - Default: 4 sec.
Timeout before starting the call (after the last digit).
Pause before dialing (s) - Default: 5 sec.
Timeout before the automatic dialing of the number insert is UMTS Routing Table (Route to FXS).
Flash detection max (ms)
It indicates the maximum time of line interruption that the device interprets as Flash. A longer time of line interruption is interpreted
as a disconnection.
5.20
It enables the display of the caller's telephone number on the display of the telephone connected to the
Gateway. The Calling party number is transmitted on FXS port by FSK.
Disable CLI
Configuration