Table of Contents
Advertisement
3G Gateway Series
Volume Rx and Tx - Default: 7
Set the volume on FXS port, from 0 (silence) to 10 (high +6db). The step is 2db.
Autocall
Autocall enabled. If after having engaged the 3G Gateway line no number is dialed within the preset Timeout, 3G Gateway will
make a call to the number set in "Phone Number" field.
Ringing
It displays the values (frequency and cadence) of the Ring generated on the FXS port. The parameters can be customized.
Signaling
If reverse polarity is enabled, 3G Gateway will change the line polarity to notify the call status.
Tone
It displays the Frequency and Cadence of Dial tone, Busy tone and Congestion tone generated on the FXS port. The parameters
can be customized.
To enable double frequency tone insert the value in the second column (blank is disabled).
Default
It reloads the factory settings with the "Tone" values.
5.3.3. FXO
Page for the configuration of FXO (Line) interface.
Ring before pickup – Default:1
Define the ring numbers before pickup the line.
Flash (generation - ms): It's the line stop time that 3G Gateway reproduces to its FXO interface (to the PABX) when, in the Mobile
Extension application, it receives the DTMF set in GSM code for Flash.
Volume Rx and Tx
Set the volume on FXO port, from 0 (silence) to 10 (high +4,5db). The step is 1,5db.
GSM code for Flash (#): It defines the DTMF code that MEX must digit so that 3G Gateway sends a flash to the PABX (FXO) in
the Mobile Extension application.
Configuration
5.21
Advertisement
Table of Contents
