Aligning Tailstock - Grizzly G4791 Owner's Manual

Aligning Tailstock

To align the tailstock:
1.
Page 16
2.
Note: If the tailstock is slightly out of align-
ment by a few thousands of an inch, the
center drill will find the center point during the
drilling process. If the tailstock appears gross-
ly out of alignment, move the tailstock until it
appears to be centered (refer to the previous
subsection for detailed instructions).
3.
Figure 40
Note: As long as the fabricated dead center
remains in the chuck, the point of this center
will remain true to the spindle axis or center
line. Keep in mind that the point will have to
be re-finished whenever it is removed and
re-installed in the chuck.
Figure 40.
4.
5.
Step 5
Figure 41.
6.
7.
8.
Figure 42.
Step 2
Figure 41
thicker
toward
half
Figure 42