Adjusting Gibs - Grizzly G4791 Owner's Manual

Adjusting Gibs

NOTICE
Excessively loose gibs may cause poor
workpiece finishes, and may cause undue
wear of the sliding surfaces. Over-tightening
the gibs may cause premature wear of these
sliding surfaces.
Saddle and Table Gibs
Tools Needed
To adjust the saddle and table gibs:
1.
2.
Figure 102.
3.
4.
5.
Compound Gib
Tools Needed
To adjust the compound gib:
1.
2.
Qty
Figure 102
Note: Turning the set screws clockwise will
tighten the gib, and turning them counter-
clockwise will loosen the gib.
Steps 2–4
Figure 103.
Qty
Figure 103