Set Up Client-To-Gateway Vpn (Telecommuter Example); Configure Gateway A (Vpn Router At Main Office) - NETGEAR N600 DGND3800B User Manual

N600 Wireless Dual Band Gigabit VDSL2 Modem Router DGND3800B
Verify that the firmware is up to date, and make sure you have all the addresses and
parameters to be set on both sides. Assure that there are no firewall restrictions.
Table 9. Configuration summary (telecommuter example)
VPN Consortium Scenario
Type of VPN:
Security scheme:
IP addressing:
Gateway
Client
Gateway A
192.168.0.1/24
(main office)
LAN IP
192.168.0.1
Figure 22. Telecommuter example

Set Up Client-to-Gateway VPN (Telecommuter Example)

Setting up a VPN between a remote computer running the NETGEAR ProSafe VPN client
and a network gateway involves two steps, described in the following sections:
•

Configure Gateway A (VPN Router at Main Office)

• Configure Gateway B (VPN Router at Regional Office)
the NETGEAR ProSafe VPN client endpoint.
Configure Gateway A (VPN Router at Main Office)
To configure a VPN tunnel:

1. Log in to the VPN router.
2. Select ADVANCED > Advanced - VPN > VPN Policies.
3. Click the Add Auto Policy button.
The VPN - Auto Policy screen displays.
Scenario 1
Client-to-gateway, with client behind NAT router
IKE with pre-shared secret/key (not certificate based)
Fully qualified domain name (FQDN)
Dynamic
WAN IP WAN IP
Internet
0.0.0.0
FQDN
toGW_A
ntgr.dyndns.org
from_GW_A
VPN Configuration
159
Client PC
Gateway B
(regional office)
IP: 192.168.2.3
(running NETGEAR
ProSafe VPN client)
on page 159.
on page 160 describes configuring