N600 Wireless Dual Band Gigabit VDSL2 Modem Router DGND3800B
To establish VPN connectivity, Gateway A has to be configured to use Dynamic DNS, and
Gateway B has to be configured to use a DNS host name provided by a DDNS service
provider to find Gateway A. Again, the following step-by-step procedures assume that you
have already registered with a DDNS service provider and have the configuration information
necessary to set up the gateways.
Step-by-Step Configuration
To configure a VPN tunnel:
1.
Log in to Gateway A (your modem router) as described in
Installation
on page 21.
This example assumes that you have set the local LAN address as 10.5.6.1 for Gateway
A and have set your own password.
2.
On Gateway A, configure the Dynamic DNS settings.
a. Select ADVANCED > Advanced Setup > Dynamic DNS.
b. Fill in the fields with account and host name settings.
•
Select the Use a Dynamic DNS Service check box.
•
In the Host Name field, type dgnd3800.dyndns.org.
•
In the User Name field, enter the account user name.
•
In the Password field, enter the account password.
c. Click Apply.
d. Click Show Status.
The resulting screen should show Update OK: good:
VPN Configuration
156
Use NETGEAR genie after