Replacing A Hard Disk Drive/Solid State Drive - Cisco Wide Area Virtualization Engine 594 and 694 Installation Manual

Replacing a Hard Disk Drive/Solid State Drive

Review the information in the
Step 1
Guidelines" section on page
Power down the appliance.
Step 2
Note
Locate the Interface Module slot in the appliance chassis and slide the Cisco Interface Module into the
Step 3
slot until the ejector lever is seated.
To remove an Interface Module, first use the ejector lever to unlatch and then pull out the Interface
Module. (See
Figure 4-1
1
Power on the appliance.
Step 4
For information about connecting cables to the Cisco WAVE Interface Module ports, see
Step 5
"WAVE Interface Modules."
Replacing a Hard Disk Drive/Solid State Drive
The WAVE appliance supports as many as two 2.5-inch (Small Form Factor) hard drives. The WAVE-594
supports SATA drives and the WAVE-694 supports SAS drives.
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
4-2
"Safety Warnings and Cautions" section on page 2-1
2-2.
You must power down the appliance before installing or removing an Interface Module. Interface
Modules are not hot-swappable.
Figure 4-1.)
Interface Module—Removal
Chapter 4 Installing Hardware Options for the WAVE-594 and WAVE-694
2
and the "Safety
Chapter 5,
OL-24619-02