Chapter 5 Wave Interface Modules; Interface Module Descriptions; Gigabit Ethernet Interface Module-Copper - Cisco Wide Area Virtualization Engine 594 and 694 Installation Manual

WAVE Interface Modules
This chapter describes Cisco WAVE Interface Modules and contains the following sections:
•
•
•
•
For information on installing an inline adapter in your WAVE-594 and WAVE-694, see the
Cisco WAVE Interface Module" section on page
For adapter specifications, see

Interface Module Descriptions

The WAVE appliance supports one optional 4-port Copper Gigabit Ethernet Interface Module, 8-port
Copper Gigabit Ethernet Interface Module, 4-port Fiber Optic Gigabit Ethernet Interface Module, or
2-port SFP+ Fiber Optic 10 Gigabit Ethernet Interface Module.
This section contains the following topics:
•
•
•
•
Gigabit Ethernet Interface Module—Copper
The copper Gigabit Ethernet Interface Module is available in 4 or 8 ports. Both models support bypass.
(See
OL-24619-02
Interface Module Descriptions, page 5-1
Ports and LED Indicators, page 5-5
Network Adapter Cabling Requirements, page 5-8
Installation Scenarios and Cabling Examples for Fast Ethernet Connections, page 5-10
Gigabit Ethernet Interface Module—Copper
Gigabit Ethernet Interface Module—Fiber Optic
10 Gigabit Ethernet Interface Module—Fiber Optic SFP+
Inline Interface
Figure 5-1 and Figure 5-2.)
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
C H A P T E R
4-1.
Table A-2 in Appendix A.
5
"Installing a
5-1