Cisco Wide Area Virtualization Engine 594 and 694 Installation Manual page 47

Chapter 4 Installing Hardware Options for the WAVE-594 and WAVE-694
Power down the WAVE appliance.
Step 1
Remove the WAVE appliance from the rack.
Step 2
Remove the primary access panel (See the
Step 3
Open the DIMM slot latches for slots A1, A2, B1, and B2 and remove the existing memory modules.
Step 4
Note
Open the DIMM slot latches for slots A3 and B3.
Step 5
To upgrade from 8 GB to 12 GB on a WAVE-594, install a 2-GB RDIMM memory module into all six
Step 6
slots. (See
To upgrade from 16 GB to 24 GB on a WAVE-694, install a 4-GB RDIMM memory module into all six
slots. (See
Figure 4-6
Check to make sure that the DIMM latches are fully engaged in the notches.
Step 7
Install the access panel.
Step 8
Lower the access panel onto the WAVE appliance and then slide the access panel toward the back of
a.
the WAVE appliance.
Tighten the screw on the top that secures the access panel to the WAVE appliance.
b.
Install the WAVE appliance into the rack.
Step 9
For complete rack installation and removal instructions, see
WAVE-694."
Install the appliance only in a rack cabinet with perforated doors.
Caution
OL-24619-02
All existing memory must be removed and replaced by the RDIMMS contained in the Cisco
upgrade kit.
Figure 4-6.)
Figure 4-6.)
Installing an RDIMM
2
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
"Removing the Cover" section on page
1
Chapter 3, "Installing the WAVE-594 and
Installing Memory
4-6).
2
4-9