Mounting In A 4-Post Rack - Cisco Wide Area Virtualization Engine 594 and 694 Installation Manual

Chapter 3 Installing the WAVE-594 and WAVE-694
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you
must take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the
top with the heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting
or servicing the unit in the rack.

Mounting in a 4-Post Rack

Follow these steps to mount the WAVE appliance in a 4-post rack:
Step 1 Prepare for installation by reading the
page
installation.
Attach the front rack mount brackets (item #1 in
Step 2
in Table
Attach the rear rack mount holder brackets (item #2 in
Step 3
(item #5 in
Note
Figure 3-1
OL-24619-02
3-1) and verify that you have the correct tools and rack-mount hardware necessary for the
3-1). (See Figure 3-4.)
Table 3-1).
The front arrow must point toward the front of the chassis.
Attaching the Brackets
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
Rack Mounting and Cabling the WAVE-594 and WAVE-694
Statement 1006
"Rack-Mounting Considerations, Parts, and Tools" section on
Table 3-1) using the six front bracket screws (item #4
Table 3-1) using the six rear bracket holder screws
3-3