Replacing A Hard Disk Drive/Solid State Drive; Figure - Cisco 7541 Hardware Installation Manual

Replacing a Hard Disk Drive/Solid State Drive

Step 1
Review the information in the
2, "Preparing to Install the WAVE-7541, WAVE-7571, and WAVE-8541."
Step 2
Power down the appliance.
Note
Step 3
Locate the Interface Module slot in the appliance chassis and slide the Interface Module into the slot
until the ejector lever is seated.
To remove an Interface Module, first use the ejector lever to unlatch and then pull out the Interface
Module. (See

Figure 4-1

1
Step 4
Power on the appliance.
Step 5
For information about connecting cables to the Cisco WAVE Interface Module ports, see
"WAVE Interface Modules."
Replacing a Hard Disk Drive/Solid State Drive
The WAVE appliance supports as many as eight 2.5-inch (Small Form Factor) SAS hard drives.
Note
The WAVE-8541 supports both Solid State Drives and Hard Disk Drives. You cannot mix HDD and SSD
in the same chasis.
For details about the WAVE-8541 appliance specifications, see
Cisco Wide Area Virtualization Engine 7541, 7571, and 8541 Hardware Installation Guide
4-2
Chapter 4 Installing Hardware Options for the WAVE-7541, WAVE-7571, and WAVE-8541
Safety Warnings and Cautions
You must power down the appliance before installing or removing an Interface Module. Interface
Modules are not hot-swappable.
Figure 4-1.)
Interface Module—Removal
and Safety Guidelines
2
Appendix A, "Appliance
sections in Chapter
Chapter 5,
Specifications".