Cisco Wide Area Virtualization Engine 594 and 694 Installation Manual page 48

Installing Memory
Do not leave open spaces above or below an installed appliance in the rack cabinet. To help prevent
Caution
damage to appliance components, always install a filler panel to cover the open space and to help ensure
proper air circulation. See the documentation that comes with your rack cabinet for more information.
Connect the cables and power cords. For information on connecting cables and power cords, see the
Step 10
"Rack Mounting and Cabling the WAVE-594 and WAVE-694" section on page
Reboot the WAVE appliance.
Step 11
Use the show memory EXEC mode command to verify that the memory you installed is recognized by
Step 12
the WAVE appliance.
Repartition the disks, using the disk delete-data-partitions command, and reload.
Step 13
Note
Note
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
4-10
Repartitioning the disks deletes all data, including all virtual blades on the hardware.
Repartitioning the disks is required after adding memory to reset the DRE space allocation.
Chapter 4 Installing Hardware Options for the WAVE-594 and WAVE-694
3-2.
OL-24619-02