Cisco Wide Area Virtualization Engine 594 and 694 Installation Manual page 30

Rack Mounting and Cabling the WAVE-594 and WAVE-694
Always use filler panels to fill empty vertical spaces in the rack. This arrangement ensures proper
Caution
airflow. Using a rack without filler panels results in improper cooling that can lead to thermal damage.
•
Rack-mounting the WAVE-594 and WAVE-694 appliance is supported for rear mount in a 4-post rack or
Note
front mount in a 2-post rack.
Table 3-1
screwdriver. Verify that you have received the following items for the installation:
Table 3-1
Item
1
2
3
4
5
6
7
Rack Mounting and Cabling the WAVE-594 and WAVE-694
There are two ways you can rack mount the WAVE appliance. The following topics are included in this
section:
•
•
•
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
3-2
Observe the following additional requirements to ensure adequate airflow and to prevent damage to
the equipment:
Front and rear doors—If the 42U rack includes closing front and rear doors, you must allow
–
5,350 sq cm (830 sq in) of holes evenly distributed from top to bottom to permit adequate
airflow (equivalent to the required 64 percent open area for ventilation).
Side—The clearance between the installed rack component and the side panels of the rack must
–
be a minimum of 7 cm (2.75 in).
lists the rack mounting hardware included in your shipping container. You will need a Phillips
Rack Mount Hardware Provided
Name Description
Front rack mount Front rack mount L bracket
bracket
Rear rack mount Rear rack mount bracket holder
bracket holder
32" rear rack mount Rear rack mount bracket (32 inch)
bracket
Front rack mount Front rack bracket screw, #6-32 x 0.30", Wafer
bracket screw Head, Phillips, Steel w/ Zinc and Black
Rear rack mount Rear bracket holder screw, M4 x0.7 x 4.85 mm,
bracket holder screw 120º, Flat Head, Phillips, Steel w/ Zinc and Black
Rack screw Rack screw, #10-32 x 0.50", Truss Head, Phillips,
Steel w/ Ni and Black
Rack screw Rack screw, M5 x 12.7 mm, Truss Head, Phillips,
Steel w/ Ni and Black
Mounting in a 4-Post Rack
Front-Mounting in a 2-Post Rack
Cabling
Chapter 3 Installing the WAVE-594 and WAVE-694
Qty
2
2
2
6
6
8
8
Rack Type
2-post 4-post
X X
X
X
X X
X
X X
X
OL-24619-02