System Functions; Testing The System - Honeywell LYNX Touch Security System User Manual

SYSTEM FUNCTIONS

Testing the System (to be conducted weekly)
Test Modes
The Test icon provides access to the Walk Test, Dialer Test and Reboot functions. The Walk
Test mode allows each protection point to be checked for proper operation. When the Walk
Test mode is active, the control sounds a single beep every 30 seconds as a reminder that the
system is in the Test mode. The Dialer Test performs a check of the system dialer. The
Reboot feature allows you to reboot the system if required.
NOTE: An alarm message will not be sent to your alarm monitoring company during these tests.
Entering Test Mode
Disarm the system and close all protected windows, doors, etc. The "Ready" indicator should
be lit.
Testing or Rebooting the System
Ready To Arm
Arm Away Arm Stay
Delay 10:18 AM June 8, 2010
Ready To Arm
Program the system
Enter Code:
Cancel
Tools
Dashboard Settings
Back
5100-100-003-V0
1 2 3
4 6
5
7 9
8
Clear 0
5000-100-009-V0
1. With the system in the disarmed state,
select the "Tools" icon from the second page
of the Home Screen. The system displays
the Keypad screen.
2. Enter your 4-digit Master User Code. The
system displays
programming screen.
– 74 –
the Master User