Bypassing Protection Zones - Honeywell LYNX Touch Security System User Manual

SECURING THE PREMISES SECURING THE PREMISES SECURING THE PREMISES SECURING THE PREMISES

Bypassing Protection Zones

Bypassing Individual Zones
The Bypass feature can be used when you want to intentionally arm your system with one or
more zones unprotected. Bypassed zones are unprotected and will not cause an alarm when
violated while your system is armed. All bypasses are removed when an Off sequence
is performed. The system will not allow panic, fire or CO zones to be bypassed.
Bypassing Zones
Ready To Arm
Arm Away Arm Stay
Delay
10:18 AM June 8, 2010
Not Ready To Arm - Fault
2. Front
Door
FAULT
Bypass All Clear
Faulted
Bypasses
Not Ready to Arm - Fault
Bypass Selected Zones
Enter Code:
Cancel
72
Zones Automation
Message Phone
More
5000-100-006-V1
Select
Bypass
Fault
5000-100-141-V0
1 2 3
4 6
5
7 9
8
Clear 0
5000-100-067-V0
– 28 –
1. With the system in the disarmed state,
select the "Zones" icon. The system displays
the Zones/Bypass screen.
2. Select the zone(s) that you wish to bypass
and then select "Bypass" OR if programmed,
the "Bypass All Faulted" button allows you to
bypass all faulted zones (excluding Panic,
Fire or CO zones). The system displays a
keypad.
3. Enter a valid Code. The system returns to
the Bypass screen and the zone(s) that are
bypassed will be displayed.
4. Select the icon to return to the home
screen.
5. Arm the system normally. See Arming the
System section for the procedure.