Connecting To 100Base-Fx And 1000Base-Sx Ports - Cisco WS-C2950-12 Hardware Installation Manual

Chapter 2 Installation

Connecting to 100BASE-FX and 1000BASE-SX Ports

Caution
Step 1
Step 2
Figure 2-34 Connecting to a 100BASE-FX or 1000BASE-SX Port
SYS T
1x
RPS
2x
3x
4x
STA T 5x
UTI L
DU PLX
SPE ED 6x
7x
8x
MO DE
78-11157-03
The 100BASE-FX and 1000BASE-SX ports operate only in full-duplex mode.
You can connect a 100BASE-FX or 1000BASE-SX port to an SC or ST port on
another device by using one of the MT-RJ fiber-optic patch cables listed in
Table 2-1. Use the Cisco part numbers in
you need.
Follow these steps to connect the switch to a 100BASE-FX or 1000BASE-SX
device:
Do not remove the dust plugs from the fiber-optic ports or the rubber caps from
the fiber-optic cable until you are ready to connect the cable. The plugs and caps
protect the fiber-optic ports and cables from contamination and ambient light.
Remove the dust plugs from the 100BASE-FX or 1000BASE-SX port and the
rubber caps from the MT-RJ patch cable. Store them for future use.
Insert the cable in a 100BASE-FX or 1000BASE-SX port. (See
10 Ba se -T
9x / 10 0B as
10 x e-T X
11 x
12 x
13 x
14 x
15 x
16 x
17 x
18 x
19 x
20 x
21 x
MT-RJ
patch cable

Connecting to 100BASE-FX and 1000BASE-SX Ports

Table 2-1
Ca ta ly st 29
50
SER IES
22 x
10 0B as e-F
23 x
24 x X
25
26
Dust plug
Catalyst 2950 Desktop Switch Hardware Installation Guide
to order the patch cables that
Figure 2-34.)
2-37