Connecting To 100Base-Fx Ports - Cisco WS-C2950-24 Hardware Installation Manual

Chapter 2 Installation

Connecting to 100BASE-FX Ports

Caution
Step 1
Step 2
Figure 2-28 Connecting to a 100BASE-FX Port
SYS T
1x
RPS
2x
3x
4x
STA T 5x
UTI L
DU PLX
6x
SPE ED
7x
8x
MO DE
78-11157-02
The 100BASE-FX ports only operate at 100 Mbps and full-duplex mode.
You can connect a 100BASE-FX port to an SC or ST port on a compatible device
by using one of the MT-RJ fiber-optic patch cables listed in
Cisco part numbers in
Follow these steps to connect the switch to a 100BASE-FX device:
Do not remove the rubber plugs from the fiber-optic ports or the rubber caps
from the fiber-optic cable until you are ready to connect the cable. The plugs
and caps protect the fiber-optic ports and cables from contamination and
ambient light.
Remove the rubber plugs from the 100BASE-FX ports and the rubber caps from
the MT-RJ patch cable. Store them for future use.
Insert the cable in a 100BASE-FX port. (See
10 Ba se -T
9x
/ 10 0B as
10 x e-T X
11 x
12 x
13 x
14 x
15 x
16 x
17 x
18 x
19 x
20 x
21 x
MT-RJ
patch cable
Table 2-1 to order the patch cables that you need.
Ca ta ly st 29
50
SER IES
22 x
23 x 10 0B as e-F
24 x X
25
26
Rubber
plug
Catalyst 2950 Desktop Switch Hardware Installation Guide
Connecting to 100BASE-FX Ports
Table 2-1. Use the
Figure 2-28.)
2-33