Chapter 2
Installation
Connecting to 1000BASE-T GBIC Module Ports
Caution
Step 1
Note
Figure 2-36 Connecting to a 1000BASE-T GBIC Port
Step 2
78-11157-03
After installing the 1000BASE-T GBIC in the GBIC module slot, follow these
steps:
To prevent ESD damage, follow your normal board and component handling
procedures.
When connecting to servers, workstations, and routers, insert a four twisted-pair,
straight-through cable in the RJ-45 connector. When connecting to switches or
repeaters, insert a four twisted-pair, crossover cable (see
When connecting to a 1000BASE-T device, be sure to use a four twisted-pair,
Category 5 cable.
1
Insert the other cable end in an RJ-45 connector on a target device.
C a ta ly s t 2
9 5 0
S E R IE S
2
Catalyst 2950 Desktop Switch Hardware Installation Guide
Connecting to GBIC Module Ports
Figure
2-36).
2-41