Installing The Switch On A Table, Shelf, Or Desk; Installing The Gbic Modules - Cisco WS-C2950-12 Hardware Installation Manual

Installing the Switch on a Table, Shelf, or Desk

Figure 2-17 Attaching the Cable Guide
SYS T
1x
RPS
STA T
UTIL
DUP LX
SPE ED
MOD E
Cable guide screw

Installing the Switch on a Table, Shelf, or Desk

Installing the GBIC Modules

Catalyst 2950 Desktop Switch Hardware Installation Guide
2-20
2x
3x
4x
5x
6x
7x
8x
10 Ba se-
9x T / 10 0B
10 x ase -TX
11 x
12 x
13 x
14 x
15 x
Before placing the switch on a table, shelf, or desk, locate the adhesive strip with
rubber feet in the mounting-kit envelope, and attach four rubber feet to the
recessed areas on the switch bottom. Place the switch on a table, shelf, or desk
near an AC power source or DC-input power source.
Start the terminal-emulation software and provide power to the switch. See the
"Powering On the Switch"
Figure 2-18, Figure 2-19, and
a GBIC module slot on the switch. For instructions about how to install a CWDM
GBIC module in a GBIC module slot, refer to the documentation that came with
that GBIC module.
For detailed instructions on installing, removing, and cabling the GBIC module
(the 1000BASE-X module, the 1000BASE-T module, the CWDM GBIC module,
or the GigaStack module), refer to your GBIC documentation.
16 x
17 x
18 x Ca tal ys t 29
19 x
50
20 x SER IES
21 x
22 x
23 x
24 x
section for instructions.
Figure 2-20 show how to insert a GBIC module in
Chapter 2 Installation
78-11157-03