Adding A New Lowest Level Of Pnni Hierarchy - Cisco Catalyst 8540 MSR Configuration Manual

Appendix
The following example shows how to delete the old static route from switch T4:
SanFran.BldA.T4# configure terminal
Enter configuration commands, one per line.
SanFran.BldA.T4(config)# no atm route 47.0091.4455.6677.11 atm0/0/3
SanFran.BldA.T4(config)# end
SanFran.BldA.T4#
The following example verifies that the old static route on switch T4 has been deleted:
SanFran.BldA.T4# show atm route
Codes: P - installing Protocol (S - Static, P - PNNI, R - Routing control),
P T Node/Port
~ ~~ ~~~~~~~~~~~~~~~~ ~~ ~~~ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
P I 12
P SI 2
P I 9
P SI 1
R I 1
R I 1
R I 1
The following example shows how to delete the old static route from switch T3:
NewYork.BldB.T3# configure terminal
Enter configuration commands, one per line.
NewYork.BldB.T3(config)# no atm route 47.0091.4455.6677.22 atm 0/0/2
NewYork.BldB.T3(config)# end
NewYork.BldB.T3#
To verify the deletion of the old static route on switch T3, use the show atm route command.

Adding a New Lowest Level of PNNI Hierarchy

Figure A-3
Figure A-3
OL-7396-01
T - Type (I - Internal prefix, E - Exterior prefix, SE -
Summary Exterior prefix, SI - Summary Internal prefix,
ZE - Suppress Summary Exterior, ZI - Suppress Summary Internal)
St Lev Prefix
0 UP 0
0 UP 0
0 UP 0
0 UP 0
ATM2/0/0 UP 0
ATM2/0/0 UP 0
ATM2/0/0 UP 0
shows an example network configured with only one level of PNNI hierarchy at level 56.
One-Level PNNI Hierarchical Network
T5
SanFran.BldA.T5
T4
SanFran.BldA.T4
End with CNTL/Z.
47.0091.4455.6677.1144/72
47.0091.4455.6677.2233/72
47.0091.4455.6677.2233.1011.1244/104
47.0091.4455.6677.2233.1011.1266/104
47.0091.4455.6677.2233.1011.1266.0060.3e7b.2001/152
47.0091.4455.6677.2233.1011.1266.0060.3e7b.2002/152
47.0091.4455.6677.2233.1011.1266.4000.0c/128
End with CNTL/Z.
NewYork.BldB.T3
T3
NewYork.BldB.T2
T1
NewYork.BldB.T1
ATM Switch Router Software Configuration Guide
Adding a New Lowest Level of PNNI Hierarchy
T2
Level 56
A-7