Configuring Two-Ended Soft Pvp Connections - Cisco Catalyst 8540 MSR Configuration Manual

Configuring Two-Ended Soft PVC and Soft PVP Connections

Configuring Two-Ended Soft PVP Connections

To configure a two-ended soft PVP connection, follow these steps:
.
Command
Step 1
Switch-C(config)# atm filter-set name [index
[number]] [permit | deny] [template | time-of-day
{anytime | start-time {end-time}}]
Step 2
Switch-C(config)# interface atm
card/subcard/port
Switch-C(config-if)#
Step 3 Switch-C(config-if)# atm soft-vp dest-vpi
passive [upc upc] [rx-cttr index] [tx-cttr index]
[access-control {src-address atm-address |
filter-set name}]
Step 4
Switch-B(config-if)# atm soft-vp source-vpi
dest-address atm-address dest-vpi [enable |
disable] [upc upc] [rx-cttr index] [tx-cttr index]
[retry-interval [first retry-interval] [maximum
retry-interval]]
Step 5 Switch-C(config-if)# end
Step 6
Switch-C# show atm vp interface atm
card/subcard/port vpi
The default value for the upc option is pass.
Note
For VBR-nrt and VBR-rt service categories you must configure the MBS (even if the value is default)
Note
in the ATM connection traffic table row attached to the passive leg.
You can use the debug atm sig-soft (interface) and debug atm rm events commands to get information
Note
on why a passive leg is not used due to traffic parameter mismatches.
Examples
The following example shows the configuration of the two-ended soft PVC (shown in
a passive half leg starting with the configuration of Switch-C.
Switch-C(config)# interface atm 0/0/1
Switch-C(config-if)# atm soft-vc 1 60 passive
Switch-C(config-if)# end
Switch-C#
ATM Switch Router Software Configuration Guide
7-40
Chapter 7 Configuring Virtual Connections
Purpose
(Optional) Used to configure the access-control
filter-set parameter on the passive
destination-side of the soft VP.
Selects the interface, on the terminating switch,
being configured.
Configures the passive leg on the terminating
switch interface.
Creates a two-ended soft PVP on the source
switch that uses the passive half leg on the
terminating switch.
Switches to EXEC command mode.
Displays the passive half-leg configuration
information of two-ended soft PVP.
Figure 7-8) with
OL-7396-01