Configuring Atm Rmon; Rmon Overview - Cisco Catalyst 8540 MSR Configuration Manual

Configuring ATM RMON

The following example shows the remote logging configuration using the show atm accounting EXEC
command:
Switch# show atm accounting
ATM Accounting Info:
Trap Threshold - 90 percent (4500000 bytes)
Interfaces:
File Entry 1 -
Selection Entry 1 -
Active List Bitmap - FF.FE.BF.FC
Configuring ATM RMON
This section describes the process you use to configure ATM RMON on the ATM switch router. The
following sections describe the process:
•
•
•
•
•
•

RMON Overview

The ATM RMON feature allows you to monitor network traffic for reasons such as fault monitoring or
capacity planning. The ATM RMON feature is an extension of an existing, well-known RMON standard
and provides high-level per-host and per-conversation statistics in a standards-track MIB similar to the
following RMON MIBs:
•
•
The ATM-RMON counter uses the per-VC counters already maintained in the hardware and polled by
the software. The ATM RMON agent can report cell traffic statistics by monitoring connection
management activity. At connection setup and release time, some ATM-RMON bookkeeping code is
executed. The amount of information varies, depending on the ATM RMON configuration. The
ATM-RMON bookkeeping capability significantly reduces the processing requirements for
ATM-RMON, and allows collecting statistics on many or all the of ATM switch router ports at once.
ATM Switch Router Software Configuration Guide
15-14
AdminStatus - UP;
AT1/0/0
AT2/0/0
Name: acctng_file1
Descr: atm accounting data
Min-age (seconds): 0
Failed_attempt : soft regular
Interval (seconds) : 60
Collect Mode : on-release periodic
Sizes: Active 68 bytes (#records 0); Ready 74 bytes (#records 0)
Remote Log and local storage are enabled.
Primary Log Host: eagle, TCP listen port: 2001, OperStatus: DOWN
Alternate Log Host: eagle, TCP listen port: 2002, OperStatus: DOWN
Subtree OID : 1.3.6.1.4.1.9.10.18.1.1
List Bitmap : FF.FE.BF.FC
Conn Type : svc-in svc-out pvc pvp spvc-originator spvc-target
RMON Overview, page 15-14
Configuring Port Select Groups, page 15-15
Configuring Interfaces into a Port Select Group, page 15-16
Enabling ATM RMON Data Collection, page 15-17
Configuring an RMON Event, page 15-18
Configuring an RMON Alarm, page 15-19
RMON-1 MIB—RFC 1757
RMON-2 MIB—RFC 2021 and 2074
Chapter 15 Configuring ATM Accounting, RMON, and SNMP
OperStatus : UP
OL-7396-01