Configuring The Bootp Server - Cisco Catalyst 8540 MSR Configuration Manual

Configuring the BOOTP Server

IDPROM in slot 0 not properly programmed
cisco C8540MSR (R5000) processor with 262144K bytes of memory.
R5000 processor, Implementation 35, Revision 2.1 (512KB Level 2 Cache)
Last reset from power-on
3 Ethernet/IEEE 802.3 interface(s)
11 ATM network interface(s)
507K bytes of non-volatile configuration memory.
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash PCMCIA card at slot 1 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
%ENABLING INTERFACES.PLEASE WAIT...
%Secondary CPU has not booted IOS
Press RETURN to get started!
If an rommon> prompt appears, your switch requires a manual boot to recover. Refer to the
Note
Configuration Fundamentals Configuration Guide for instructions on manually booting from Flash
memory.
Configuring the BOOTP Server
The BOOTP protocol automatically assigns an Ethernet IP address by adding the MAC and IP addresses
of the Ethernet port to the BOOTP server configuration file. When the switch boots, it automatically
retrieves the IP address from the BOOTP server.
The switch performs a BOOTP request only if the current IP address is set to 0.0.0.0. (This is the default
for a new switch or a switch that has had its startup-config file cleared using the erase command.)
To allow your ATM switch router to retrieve its IP address from a BOOTP server, you must first
determine the MAC address of the switch and add that MAC address to the BOOTP configuration file
on the BOOTP server. The following steps provide an example of creating a BOOTP server configuration
file:
Command
Step 1 —
Step 2
—
Step 3
—
Step 4
Switch# reload
ATM Switch Router Software Configuration Guide
3-4
Chapter 3
Purpose
Installs the BOOTP server code on the workstation, if it is not
already installed.
Determines the MAC address from the label on the chassis.
Adds an entry in the BOOTP configuration file (usually
/usr/etc/bootptab) for each switch. Press Return after each entry
to create a blank line between each entry. See the example
BOOTP configuration file that follows.
Restarts the ATM switch router to automatically request the
IP address from the BOOTP server.
Initially Configuring the ATM Switch Router
OL-7396-01