Displaying The Frame Relay To Atm Connection Traffic Table; Configuring The Interface Resource Management Tasks - Cisco Catalyst 8540 MSR Configuration Manual

Configuring Frame Relay to ATM Resource Management
Example
The following example shows how to configure a Frame Relay to ATM CTT row with non-real-time
variable bit rate (VBR-NRT) service category, committed information rate of 64000 bits per second, a
peak information rate of 1536000 bits per second, and a committed burst size of 8192 bits per second:
Switch(config)# frame-relay connection-traffic-table-row 64000 8192 1536000 vbr-nrt
Allocated index = 64000
Switch(config)#

Displaying the Frame Relay to ATM Connection Traffic Table

To display the Frame Relay to ATM CTT configuration, use the following EXEC command:
Command
show frame-relay connection-traffic-table-row
[from-row row | row row]
Example
The following example shows how to display the Frame Relay to ATM CTT configuration table:
Switch# show frame-relay connection-traffic-table-row
Row
100

Configuring the Interface Resource Management Tasks

The following resource management tasks configure queue thresholds, committed burst size, and service
overflow on Frame Relay interfaces. To change any of these interface parameters, perform the following
steps, in interface configuration mode:
Command
Step 1 Switch(config-if)# frame-relay input-queue
{abr | ubr | vbr-nrt} {discard-threshold |
marking-threshold} threshold
Step 2 Switch(config-if)# frame-relay output-queue
{abr | ubr | vbr-nrt} {discard-threshold |
marking-threshold} threshold
Step 3 Switch(config-if)# frame-relay bc-default
bc-value
Step 4 Switch(config-if)# frame-relay accept-overflow Configures existing connections to accept or
Step 5 Switch(config-if)# frame-relay overbooking
percent
ATM Switch Router Software Configuration Guide
20-22
Chapter 20
cir bc be
64000 32768 32768
Configuring Frame Relay to ATM Interworking Port Adapter Interfaces
Purpose
Displays the Frame Relay to ATM CTT
configuration.
pir FR-ATM Service Category
64000
Purpose
Configures discard and marking thresholds for
the inbound direction.
Configures discard and marking thresholds for
the outbound direction.
Configures the committed burst size (in bits) used
for ABR/UBR soft VCs on the destination
interface.
discard overflow traffic (exceeding CIR) for VBR
circuits.
Unavailable on CDS3 Frame Relay
Note
interfaces.
Configures the percentage of CIR overbooking.
ATM row
vbr-nrt 100
OL-7396-01