Displaying Routes; Displaying Environment; Checking Basic Connectivity (Catalyst 8540 Msr); Checking Basic Connectivity (Catalyst 8510 Msr And Lightstream 1010) - Cisco Catalyst 8540 MSR Configuration Manual

Testing the System Management Functions

Displaying Routes

To discover the IP routes that the ATM switch router packets will actually take when traveling to their
destination, use the following EXEC command:
Command
traceroute [protocol] [destination]

Displaying Environment

To display temperature and voltage information on the ATM switch router console, use the following
EXEC command:
Command
show environment

Checking Basic Connectivity (Catalyst 8540 MSR)

To diagnose basic ATM network connectivity on the Catalyst 8540 MSR, use the following privileged
EXEC command:
Command
ping atm interface atm card/subcard/port
vpi [vci] {end-loopback [destination] |
ip-address ip-address | seg-loopback
[destination]}

Checking Basic Connectivity (Catalyst 8510 MSR and LightStream 1010)

To diagnose basic ATM network connectivity on the Catalyst 8510 MSR and LightStream 1010 ATM
switch routers, use the following privileged EXEC command:
Command
ping atm interface atm card/subcard/port
vpi [vci] {atm-prefix prefix | end-loopback
[destination] | ip-address ip-address |
seg-loopback [destination]}
ATM Switch Router Software Configuration Guide
4-24
Chapter 4 Configuring System Management Functions
Purpose
Displays packets through the network.
Purpose
Displays temperature and voltage
information.
Purpose
Uses ping to check the ATM network
connection.
Purpose
Uses ping to check the ATM network
connection.
OL-7396-01