Lane Configuration Examples; Default Configuration For A Single Emulated Lan - Cisco Catalyst 8540 MSR Configuration Manual

Atm switch router software configuration guide

Hide thumbs Also See for Catalyst 8540 MSR:

Table of Contents

Configuring LAN Emulation

LANE Configuration Examples

The examples in the following sections illustrate how to configure LANE for the following cases:

All examples use the automatic ATM address assignment method described in

Addressing and Address Templates for LANE Components, page

These examples show the LANE configurations, not the process of determining the ATM addresses and

entering them.

For LANE client configuration examples on ATM router module interfaces, see

"Configuring ATM Router Module Interfaces."

The following examples show how to configure one Cisco 7505 router, one ATM switch, and one

Catalyst 5500 switch for a single emulated LAN. Configurations for both Ethernet and Token Ring

emulated LANs are shown.

The ATM switch contains the LECS, LES, BUS, and an LEC. The router and Catalyst 5500 switch each

contain an LEC for the emulated LAN. This example uses all LANE default settings. For example, it

does not explicitly set ATM addresses for the different LANE components that are colocated on the ATM

switch. Membership in this emulated LAN is not restricted (see

Figure 14-3 Single Emulated LAN Example Network

Default configuration for a single emulated LAN with a LANE client on the ATM switch router

Default configuration for a single emulated LAN with a backup LECS and LES on the ATM switch

Default configuration for a single emulated Token Ring LAN using IP source routing across a

source-route bridged network with a LANE client on the ATM switch router

main-atm 0.1

LECS, LES/BUS, LEC

LANE Configuration Examples

ATM Switch Router Software Configuration Guide

Automatic ATM

Catalyst 8510 msr Lightstream 1010