Upgrade The Wireless Access Point Software - NETGEAR WNDAP360 Reference

Figure 33.
4. Enter the login name and password (admin and password are the defaults).
After successful login, the > prompt should appear preceded by the name of the wireless
access point. In this example, the prompt is netgear334408.
5. Enter the CLI commands that you want to use. You can enter show configuration to
display the available CLI commands. The CLI commands are also listed in
Command-Line
Note: You can also access the wireless access point remotely over a
Telnet or SSH session using an application such as PuTTY, if such
an encryption application is allowed by law in your country. After you
have connected to the wireless access point, enter the login name
and password to access the CLI.

Upgrade the Wireless Access Point Software

The software of the wireless access point is stored in flash memory and can be upgraded as
NETGEAR releases new software. You can download upgrade files from the NETGEAR
website. If the upgrade file is compressed (.zip file), you first need to extract the image (.rmt)
file before sending it to the wireless access point. You can send the upgrade file using your
browser. There are two methods to perform a software upgrade that are described in the
following sections:
• Web Browser Upgrade Procedure
• TFTP Server Upgrade Procedure
ProSafe Dual Band Wireless-N Access Point WNDAP360
Reference.
Management
61
Appendix B,