NETGEAR WNDAP360 Reference page 54

ProSafe Dual Band Wireless-N Access Point WNDAP360
Figure 28.
2. Optionally: To display the MAC Authentication screen for the 802.11a/na modes, click the
802.11a/na tab.
3. Select the Turn Access Control On check box to enable the access control feature.
4. From the Select Access Control Database drop-down list, select one of the following
database options:
• Local MAC Address Database. The wireless access point uses the local MAC
address database for access control. This is the default setting.
• Remote MAC Address Database. The wireless access point uses the MAC address
database on an external RADIUS server on the LAN for access control. If you select
this database, you first need to configure the RADIUS server settings (see
RADIUS Server Settings
5. Click Refresh to refresh the Available Wireless Stations table. The wireless access point
places the MAC addresses of the attached wireless stations in this table.
6. Populate the Trusted Wireless Stations table by one of the following methods:
• Select MAC addresses from the Available Wireless Stations table:
a. Select individual check boxes for MAC addresses, or select all MAC addresses by
selecting the check box in the heading.
b. Click Move to transfer the MAC addresses from the Available Wireless Stations
table to the Trusted Wireless Stations table.
• Enter MAC addresses manually:
a. Enter a MAC address directly in the Trusted Wireless Stations table.
b. Click Add.
To delete a MAC address from the Trusted Wireless Stations table, select individual check
boxes for MAC addresses, or select all MAC addresses by selecting the check box in the
heading, and then click Delete.
7. Click Apply to save your settings.
on page 51).
Wireless Configuration and Security
54
Configure