NETGEAR WNDAP360 Reference page 27

Configure 802.11a/na Wireless Settings

To configure the 802.11a/na wireless settings:
1. Select Configuration > Wireless > Basic > Wireless Settings. The basic Wireless
Settings screen displays. (The following figure shows the 802.11na settings.)
Figure 13.
2. Specify the wireless mode in the 5-GHz band by selecting one of the following radio buttons:
• 11a. 802.11n-compliant devices can connect to the access point because they are
backward compatible.
• 11na. This is the default setting. If you keep the default setting, go to
When you change the wireless mode, the Turn Radio On check box is automatically
cleared, and all fields, button, and drop-down list onscreen are masked out.
3. Turn on the radio by selecting the Turn Radio On check box. A popup screen displays.
Note: Under normal conditions you want the radio to be turned on. Turning off
the radio disables access through the wireless access point, which can be
helpful for configuration, network tuning, or troubleshooting activities.
4. Click OK to confirm the change of wireless mode. The change does not take effect until you
click the Apply button after you have completed the wireless configuration.
ProSafe Dual Band Wireless-N Access Point WNDAP360
Installation and Basic Configuration
27
step 5.