Configuration Summary (Telecommuter Example - NETGEAR DG834GUv5 Reference Manual

DG834G Reference Manual
In Step 1, enter toDG834 for the Connection Name.
a.
In Step 2, enter dg834g.dyndns.org for the remote WAN's IP address.
b.
In Step 3, enter the following:
c.
• IP Address = 10.5.6.1
• Subnet Mask = 255.255.255.0
Test the VPN tunnel by pinging the remote network from a PC attached to the DG834G.
7.
Open the command prompt (Start -> Run -> cmd)
a.
ping 172.23.9.1
b.
Figure C-11: ping 172.23.9.1
Note: The pings may fail the first time. If this happens, try the pings a second time.

Configuration Summary (Telecommuter Example)

The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Assure that there are no firewall restrictions.
C-14
v3.0, September 2005
NETGEAR VPN Configuration