Step 1: Configuring The Client-To-Gateway Vpn Tunnel On The Dg834G - NETGEAR DG834GUv5 Reference Manual

• "Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834G" on page -7
VPN Wizard to configure the VPN tunnel between the remote PC and network gateway.
• "Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC" on page -12
configures the NETGEAR ProSafe VPN Client endpoint.
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
DG834G
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
not covered by these VPNC-recommended parameters, refer to
VPN Tunnels in Special Circumstances" on page 8-35
The worksheet below identifies the parameters used in the following procedure. A blank
worksheet is at "Planning a VPN" on page
Virtual Private Networking
Table 8-2 on page
8-3.
v3.0, September 2005
DG834G Reference Manual
8-5. If you have special requirements
"How to Set Up
to set up the VPN tunnel.
uses the
8-7