NETGEAR DG834GUv5 Reference Manual page 124

DG834G Reference Manual
• Select All in the Protocol menu to allow all traffic through the VPN tunnel.
• Select the Connect using Secure Gateway Tunnel check box.
• Select IP Address in the ID Type menu below the check box.
• Enter the public WAN IP Address of the DG834G in the field directly below the ID Type
menu. In this example,
• The resulting Connection Settings are shown in
3. Configure the Security Policy in the NETGEAR ProSafe VPN Client software.
• In the Network Security Policy list, expand the new connection by double clicking its
name or clicking on the "+" symbol. My Identity and Security Policy subheadings appear
below the connection name.
• Click on the Security Policy subheading to show the Security Policy menu.
Figure 8-10
• Select the Main Mode in the Select Phase 1 Negotiation Mode check box.
4. Configure the VPN Client Identity.
In this step, you will provide information about the remote VPN client PC. You will need to
provide:
— The Pre-Shared Key that you configured in the DG834G.
— Either a fixed IP address or a "fixed virtual" IP address of the VPN client PC.
8-14
would be used.
22.23.24.25
v3.0, September 2005
Figure 8-10.
Virtual Private Networking